Asus p4p800s User Manual page 34

4. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)
This connector supports the provided UltraDMA100/66/33 IDE ribbon cable.
Connect the cable's blue connector to the primary (recommended) or secondary
IDE connector, then connect the gray connector to the UltraDMA100/66/33 slave
device (hard disk drive) and the black connector to the UltraDMA100/66/33 master
device. It is recommended that you connect non-UltraDMA100/66/33 devices to
the secondary IDE connector. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the hard
disk documentation for the jumper settings. BIOS supports specific device bootup.
If you have more than two UltraDMA100/66/33 devices, purchase another
UltraDMA100/66/33 cable. You may configure two hard disks to be both master
devices with two ribbon cables – one for the primary IDE connector and another
for the secondary IDE connector.
1. Pin 20 on each IDE connector is removed to match the covered hole on the
2. The hole near the blue connector on the UltraDMA100/66/33 cable is
3. For UltraDMA100/66 IDE devices, use the 80-conductor IDE cable.
P4P800S
P4P800S IDE Connectors
1-24
UltraDMA cable connector. This prevents incorrect orientation when you
connect the cables.
intentional.
®
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE1
PIN 1
Chapter 1: Product introduction
PIN 1