Filling With Special Salt - AEG FAVORIT 54730 Operating Instructions Manual

4. To memorise the new level, switch off the dishwasher by pressing the On/Off
push button.

Filling with special salt

Caution! The packaging of dishwasher salt and detergents are often very similar. The
accidental filling of the salt compartment with detergent would ruin the water
softener. Each time you add salt, make sure the carton you have in your hand really
is salt.
Only use salt specifically designed for use in dishwashers.
All other types of salt not specifically designed for use in a dishwasher,
especially table salt, will damage the water softener.
Only fill with salt just before starting one of the complete washing
programmes (not the Rinse and Hold programme). This will prevent any
grains of salt or salty water, which may have been spilled, remaining on
the bottom of the machine for any period of time, which may cause
corrosion.
To fill:
1. To fill with salt, unscrew the cap of the salt container.
2. Pour 1 litre of water inside the container (this is necessary only before
filling with salt for the first time).
3. Using the funnel provided, pour in the salt until
the container is full.
Do not worry if water overflows from the unit
when filling with salt, this is quite normal.
4. Replace the cap making sure that there is no
trace of salt on the screw thread or on the
gasket.
5. Screw on the cap tightly.
When this has been done, all that is required is to periodically top up the container
with salt.
You are reminded of this by the salt indicator light on the control panel which will
illuminate when the salt has finished.
Important!
The salt refill indicator light on the control panel can remain illuminated for 2-6
hours after salt has been replenished, assuming the dishwasher remains on. If you are
using salts that take longer to dissolve then this can take longer, the function of the
dishwasher is not affected.
SR14
11