Internal Connectors - Asus M4A88TD-V EVO/USB3 User Manual

2.8.3

Internal connectors

1. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
M4A88TD-V EVO/USB3
M4A88TD-V EVO/USB3 IDE connector
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the
same setting.
ASUS M4A88TD-V EVO/USB3
E5888_M4A88TD-V EVO-USB3_Content29 29
PRI_EIDE
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
PIN1
Mode of device(s) Cable connector
- Black
Black
Master
Slave Gray
Master
Black or gray
Slave
2-29
5/26/10 3:44:55 PM