Gigabyte G1.Sniper User Manual page 42

Profile DDR Voltage
When using a non-XMP memory module or Extreme Memory Profile (X.M.P.) is set to Disabled, this
item will display as 1.5V. When Extreme Memory Profile (X.M.P.) is set to Profile1 or Profile2, this
item will display the value based on the SPD data on the XMP memory.
Profile QPI Voltage
The value displayed here is dependent on the CPU being used.
Channel Interleaving
Options are: Auto (default), 1~6.
Rank Interleaving
Options are: Auto (default), 1~4.
>>>>> Channel A/B/C Timing Settings
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
>>>>> Channel A Standard Timing Control
x CAS Latency Time
x tRCD
x tRP
x tRAS
>>>>> Channel A Advanced Timing Control
x tRC
x tRRD
x tWTR
x tWR
x tWTP
x tWL
x tRFC
x tRTP
x tFAW
x Command Rate (CMD)
>>>>> Channel A Misc Timing Control
x B2B CAS Delay
x Round Trip Latency
higf: Move Enter: Select
F5: Previous Values
>>>>> Channel A/B/C Standard Timing Control
CAS Latency Time
Options are: Auto (default), 5~15.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~31.
>>>>> Channel A/B/C Advanced Timing Control
tRC
Options are: Auto (default), 1~63.
tRRD
Options are: Auto (default), 1~7.
BIOS Setup
Channel A Timing Settings
8 Auto
8 Auto
8 Auto
20 Auto
27 Auto
4 Auto
4 Auto
8 Auto
19 Auto
7 Auto
60 Auto
4 Auto
16 Auto
1 Auto
- Auto
50 Auto
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 42 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults