Default Configuration; Default Configuration Settings - NETGEAR WNR3500v1 - RangeMax Wireless N Gigabit Router Setup Manual

Default Configuration Settings

You can use the Restore Factory Settings button located on the back of your device to reset all
configuration settings to their factory defaults. This is called a hard reset.
• To perform a hard reset, push and hold the Restore button for approximately 5 seconds (until
the POWER status light blinks rapidly). Your device will return to the factory configuration
settings shown in
• Pressing the Restore button for a shorter period of time will simply cause your device to
reboot.
Table 1. Home Router Default Configuration Settings
Feature
Smart Wizard
Router Login
Router Login URL
Login Name (case sensitive)
Login Password (case sensitive)
Internet Connection
WAN MAC Address
MTU Size
Local Network
Router Lan IP address (the Gateway IP
address)
IP Subnet Mask
DHCP Server
Time Zone

Default Configuration

Table 1 below.
Default Configuration
Default Setting
Disabled
http://www. routerlogin.net;
http://www.routerlogin.com; or http://192.168.1.1
admin
password
Default hardware address (on label)
1500
192.168.1.1
255.255.255.0
Enabled
GMT
37