Section 3 Test Mode - Sony PRS-600 - Electronic Book Reader Service Manual

PRS-600
HOW TO MAKE THE SD MEMORY CARD FOR TEST
MODE USE ONLY
1. Ready for the SD memory card.
2. Make the new directly as "/Sony Reader/software" on the SD
memory card.
3. Make the new fi le as "/Sony Reader/software/Autorun.xml" on
the SD memory card.
4. Confi rm the method of obtaining the program data for test
mode to each service headquarters.
HOW TO ENTER THE TEST MODE
1. Insert the SD memory card with the test mode data is inserted
while pressing the [HOME] and [VOL +] buttons.
2. After a while, indicate the test mode menu, enter the test mode.
3. Press the [<]/[>] buttons, change the test mode menu page 1/
page 2.
1. Test Panel
1. Touch the "Test Panel" in the test mode menu page 1.
The screen is changed into the image fi les. (all image fi les of in
the directly as "/Sony Reader/software/images")
2. Press the [<]/[>] buttons, change the image fi les.
3. Press the [size] button, image fi le display size change to
600×800 or 500×700.
4. If there are no image fi les, screen is fi lled with grayscale color.
Press the [<]/[>] buttons, change the grayscale color.
>
WHITE LIGHT GRAY
<
<
When the setting of "17. Slideshow Setting" is turning on, the
image fi les (or grayscale color) are changes by the automatic
operation.
5. Press the [HOME] button, return to the test mode menu.
2. Drawing with point
1. Touch the "Drawing with point" in the test mode menu page 1.
The screen is changed into the drawing check.
2. The scanned coordinate is displayed while dragging.
(Screen display)
3. Press the [HOME] button, return to the test mode menu.
8
SECTION 3
TEST MODE
>
> >
DARK GRAY BLACK
< <
3. Test TP Coordinate
1. Touch the "Test TP Coordinate" in the test mode menu page 1.
The screen is changed into the touch panel coordinate.
2. The scanned coordinate is displayed pen down and pen up.
The grid is drawn every 100 pixels.
All the touch panel data is recorded in the log fi le.
(pen down, pen move, pen up, pressure)
(Screen display)
3. Press the [HOME] button, return to the test mode menu.
4. Test All Keys
1. Touch the "Test All Keys" in the test mode menu page 2.
The screen is changed into the all keys state.
(Screen display)
2. Each buttons are pressed, the display changed from white into
the black.
3. It returns to the test mode menu when all buttons are pressed.
4. After the end of test, display of the right side of "Test All
Keys" on test mode menu is changed from "Not Yet" into the
"Done".
5. Check battery
Touch the "Check battery" in the test mode menu page 1.
Display of the right side of "Check battery" on test mode menu
changes into the display of the battery level.
6. Factory Initialize
Touch the "Factory Initialize" in the test mode menu page 1.
Clean up all the evidence and reset all settings, then shutdown.
7. Version confi rmation
1. Touch the "Version confi rmation" in the test mode menu page
1.
2. Each version of this set are displayed.
3. Press the [HOME] button, return to the test mode menu.
screen coordinate
raw coordinate
pressure