Do you have a question about the Dehumidifier and is the answer not in the manual?
Questions and answers
CJ "Case" de Jong
May 8, 2025
dehumidifier not working.. shows EC
1 comments:
Mr. Anderson
May 19, 2025
The EC error code on a Frigidaire dehumidifier indicates a problem with the sealed system or condenser. This means the coils may be freezing or not condensing properly, and the unit is likely not repairable. The sealed system contains refrigerant and should only be serviced by a qualified technician.
Page 1
OWNER'S GUIDE READ AND SAVE THESE Record Model No. and Serial No. of this dehumidifier printed on the nameplate located behind the bucket. Model No. Serial No. IMPORTANT: Keep a copy of your bill of sale. The date on the bill establishes the warranty period should service be required.
Your appliance is warranted by Electrolux Ebctrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this war ranty Elect_olux authorizes no one else to change or add to any of these obligations under this warranty Any obligations tot service and parts under tMs war...
The coils condense or draw moisture from the air, and air flows through the side louvers into the room as dry, warm air. Moisture removed from air is collected in a bucket on the front of the dehumidifier. The unit is designed to operate between 41°F (5°C), and 96°F (35°C).
Page 5
3. After a few days when the Relative HUMIDITY button to choose either 50%, 60% or 70%, so the room is kept at a comfortable concentration. The unit will cycle on and off keeping the desired level of comfort. LOW 0 4.
Page 6
REMOVING COLLECTED WATER 1. Emptying the Bucket: a. When the bucket is full the unit will shut down and the BUCKET indicator light will illuminate. LOW 0 Do not move the unit at this point otherwise Press sides of bucket gently to unclip the bucket from the unit. Remove the bucket as shown in the photographs bucket.
Continuous Drainage: For constant drainage operation, drain nearby to discharge b. Remove the bucket from the unit and set aside. Lift up the side flap located on the left side of the unit as looking from the front. (fig. 1 ) Insert the female threaded e.
Select 'CONTINUOUS' by using the humidity button or knob. After the dehumidifier reset the control to the desired setting. Bucket not installed properly See "Removing Water in the bucket has reached its preset level. Dehumidifier occurs.
Need help?
Do you have a question about the Dehumidifier and is the answer not in the manual?
Questions and answers
dehumidifier not working.. shows EC
The EC error code on a Frigidaire dehumidifier indicates a problem with the sealed system or condenser. This means the coils may be freezing or not condensing properly, and the unit is likely not repairable. The sealed system contains refrigerant and should only be serviced by a qualified technician.
This answer is automatically generated
Unit not operating. The display shows FO