Installing The Hanger Bracket - Hunter 28839 Owner's Manual

CAUTION: To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel.
2-1. Drill two pilot holes into the wood support structure through the
outermost holes in the outlet box. The pilot holes should be 9/64"
in diameter.
2-2. Place a flat washer on each of the two 3" screws.
2-3. Thread the lead wires from the outlet box down through the hole
in the middle of the hanger bracket.
2-4. Align the slotted holes in the hanger bracket with the pilot holes
you drilled in the wood support structure. If you are installing the
fan on an angled ceiling, be sure to orient the hanger bracket with
the large opening toward the ceiling peak.
2-5. Pass the screws through the slotted holes in the hanger bracket
into the pilot holes you drilled.
Tighten the screws into the 9/64" pilot holes; do not use lubricants
on the screws. Do not over tighten.
Flat Washer
2 • Installing the Hanger Bracket
3" Wood Screw
7
42222-01 • 05/30/12 • Hunter Fan Company
Steps 2-2 – 2-5
Step 2-4 (Angled Ceiling Only)
For Angled Ceilings: Be sure to orient
the hanger bracket with the large
opening toward the ceiling peak.