Back-Panel Features And Indicators - Dell External OEMR R620 Owner's Manual

Drive-Status Indicator Pattern (RAID Only)
Blinks green, amber, and off
Blinks amber four times per second
Blinks green slowly
Steady green
Blinks green three seconds, amber three
seconds, and off six seconds

Back-Panel Features And Indicators

Figure 5. Back-Panel Features and Indicators—8 Hard Drive System (2 PCIe Expansion Cards)
Item Indicator, Button, or
Connector
1 System identification button
2 System identification
connector
3 iDRAC7 Enterprise port
4 Serial connector
5 PCIe expansion card slot
(riser 2)
Condition
NOTE: The drive status indicator remains off until all hard drives
are initialized after the system is turned on. Drives are not ready
for insertion or removal during this time.
Predicted drive failure
Drive failed
Drive rebuilding
Drive online
Rebuild aborted
Icon Description
The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
When one of these buttons is pressed, the LCD panel on
the front and the system status indicator on the back blink
until one of the buttons is pressed again.
Press to toggle the system ID on and off. If the system
stops responding during POST, press and hold the system
ID button for more than five seconds to enter BIOS
progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press
and hold for more than 15 seconds.
Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
Allows you to connect a serial device to the system.
Allows you to connect a PCIe expansion card.
15