Epson Apex Product Support Bulletin page 25

NUMBER:
S-0029C
Q. What type of modem can be used with the Apex?
A. IBM
PC/XT compatible
external
modems
A serial interface board or
installed to
types of modems which are available from Epson computer dealers.
The Epson Link 1200 external 1200 baud modem (Epson P/N C202A-A)
and the Epson Link 1200-PC internal modem (Epson P/N C203A-A).
Q. My computer would not work when I set the dip switches as
described in the User's Guide but it worked when I set them in
the opposite setting.
A.
An error was made in the original Apex User's Guide, Appendix A,
page A-2, for setting the dip switches. The book indicates that
the switches are
actually ON when set to the right.
is correct.
since this error was discovered.
Q: I can't find some of the programs referred to in the MS-DOS
3.2 manual on the MS-DOS diskette. Where are they?
A.
The GW-BASIC
which are referred to in the MS-DOS manual.
Q. Will my Apex work in foreign countries?
A.
The Apex
computer
internationally
voltage on the voltage selection
the unit.
The Apex will operate on either 115VAC or 230VAC at
50/60
Hz power.
One thing to be aware of,
the voltage on the power outlet on the rear of the computer is
the same as the
monitor or other device
is capable
of operating on the same voltage and frequency that
the computer is
not set up
to operate on dual voltages
plugged into
monitors and printers as well.
internal
which connect
use an external
Why?
OFF
when set to the right.
An errata sheet
diskette contains
can be used
simply by
if taking an Apex overseas,
input voltage of
plugged into this
connected to.
the wrong AC voltage.
can be
modems
serial
to a
multifunction option
modem. Epson
The Table (A-l) on page A-3
has been placed
many of the
in both the United States and
selecting the
switch located on the rear of
the computer.
outlet make sure it
Most monitors
and will be damaged if
This applies
PAGE: 6
of 6
used as well as
interface port.
board must
manufactures both
The switches are
in the manuals
utility programs
appropriate input
is that
If you
have
and printers are
to the Apex
be
a