Advertisement
Available languages
Available languages
Wall Outlet
Location
:
12"q
10"
'
i
|
, Recommended area for
' 120V grounded outlet
I on rear wall.
e
C_L o _u_N_T
22"
', NOTE: If an outlet
I is not available,
I
have one installed by
i a qualified technician.
r _
OF UNIT
Figure 3
Cooktop
Installation
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop
cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Clamp
Down
Information
Once the cooktop is installed in the counter opening,
/ou must clamp the unit down as shown.
Countertop
Cooktop
_
/
Figure 4
To clamp down, insert an angle bracket into the slot on
each side of the unit as shown.Run thumb screw up
through the bracket, up against the bottom of the
counter. Tighten until the unit draws down and is
secure.
Provide
an Adequate
Gas Supply
This cooktop is designed to operate on natural gas at 4"
of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper operation,
the maximum inlet pressure to
the regulator must be no more than 14" of water
column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1 " (or 2.5 kPa) greater than the regulator manifold
pressure setting. The regulator is set for 4" of manifold
pressure, and the inlet pressure must be at least 5".
The gas supply line to the range should be 1/2"or s4" pipe.
LP/Propane
Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
A kit for converting to LP gas is supplied with your
cooktop. The kit is marked "FOR LP/PROPANEGAS
CONVERSION".
The conversion must be performed by a qualified service
technician in accordance with the kit instructions and all
local codes and requirements. Failure to follow
instructions could result in serious injury or property
damage. The qualified agency performing this work
assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in serious personal injury and
property damage.
Important:
Remove all packing material and
literature from cooktop before connecting gas and
electrical supply to cooktop.
Install
Pressure
Regulator
Install the pressure regulator with the arrow on the
regulator pointing up toward the unit in a position
where you can reach the access cap.
Do not make the connection too tight.
The regulator is die cast. Overtightening
may crack the
regulator resulting in a gas leak and possible fire or
explosion.
Manual
GAS FLOW
Pressure
Shutoff
Flare
_
Flare
Regulator
Valve
Union
Union
_,
On,_
t
NipTpl
Nipple
Flexible
Access
Off
Connector
Cap
All connections must be wrench-tightened
- Figure 5
Advertisement
