HP Gt7725 - Compaq Thin Client Troubleshooting Manual page 37

Table 4-5 POST Error Messages (continued)
CMOS Checksum Bad
KBC BAT Test Failed
Keyboard Error
PS2 Keyboard not found
PS2 Mouse not found
Keyboard/Interface Error
Unlock Keyboard
System Halted
<INS> Pressed
Password check failed
Boot Failure...
Invalid Boot Diskette
Drive Not Ready
Reboot and Select proper Boot device or
Insert Boot Media in selected Boot device
NO ROM BASIC
CMOS contents failed the Checksum check. This error indicates that the CMOS
data has been changed by a program other than the BIOS or that the CMOS is
not retaining its date due to malfunction. This error can typically be resolved by
using AMIBIOS Setup.
Keyboard controller BAT test failed. This may indicate a problem with keyboard
controller initialization.
Keyboard is not present or the hardware is not responding when the keyboard
controller is initialized.
PS2 keyboard support is enabled in the BIOS setup but the device is not detected.
PS2 mouse support is enabled in the BIOS setup but the device is not detected.
Keyboard controller failure. This may indicate a problem with system hardware.
PS2 keyboard is locked. User needs to unlock the keyboard to continue the BIOS
POST.
The system has been halted. A reset or power cycle is required to reboot the
machine. This message appears after a fatal error has been detected.
Indicates that the INS key was pressed during BIOS POST. The POST will load
and use default CMOS settings.
The password entered does not match the password set in the setup. This
condition may occur for both Supervisor and User password verification.
This is a generic message indicated the BIOS could not boot from a particular
device. This message is usually followed by other information concerning the
device.
A diskette was found in the drive, but it is not configured as a bootable diskette.
The BIOS was unable to access the drive because it indicated it was not ready for
data transfer. This is often reported by drives when no media is present.
BIOS could not find a bootable device in the system and/or removable media drive
does not contain media.
This message occurs on some systems when no bootable device can be detected.
POST Error Messages 29