Sony MZ-N505 Service Manual page 17

SOUND SKIP CHECK RESULT DISPLAY MODE
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 13).
2. Press the key or
N N
playing or recording sound skip result display mode becomes
active respectively where the LCD displays the following.
Set LCD display
000
P**R**
Total count of play
system errors (hex.)
3. When the N key is pressed, total error count is displayed on
the LCD, and each time the
item moves down by one as shown below. Also, if the
is pressed, the display item moves up by one, then if the
[T MARK/REC]
and
N
record mode appears.
[T MARK/REC]
When the and
N
error count is displayed on the LCD, and each time
the key is pressed, the display item moves down by one
>
as shown below. Also, if the
item moves up by one, then if the
play in the play mode appears.
Playing sound skip
result display
000 P * * R**
000 E I B **
000 S t a t**
000 A d r s**
000 B E m p**
000 # # # ###
P**R** : Total play/record errors (hex.)
** : Counter of sound skip check each item (hex.)
###### : 6-digit address where sound was skipped last (hex.)
[T MARK/REC]
and keys, and the
Total count of record
system errors (hex.)
> key is pressed, the display
.
keys are pressed, the display in the
keys are pressed, total
key is pressed, the display
.
key is pressed, the dis-
N
Recording sound skip
result display
000 P* *R**
000 BO vr**
000 Bf ul**
000 Rt ry**
000 ## ####
• Cause of Sound Skip Error
Cause of error
EIB
Stat
Play
Adrs
BEmp
BOvr
Record
Bful
Rtry
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the
• Setting Method of Key Check Mode
1. Set the test mode (see page 13).
[T MARK/REC]
2. Press the
activates the key check mode. (At the last two digits, AD value of
remote commander key line is displayed in hexadecimal)
key
Remote commander LCD display
004
3. When each key on the set and on remote commander is pressed,
its name is displayed on the remote commander LCD. (The
operated position is displayed for 4 seconds after the slide
switch is operated. If any other key is pressed during this dis-
play, the remote commander LCD switches to its name dis-
play)
Example1: When the
Set LCD display
004
Example2: When the
pressed:
Set LCD display
004
MZ-N505
Description of error
Sound error correction error
Decoder status error
Address access error
Buffer is empty
Buffer is full, and sounds were
dumped
Buffer capacity becomes less,
and forcible writing occurred
Retry times over
x
and keys on the remote commander
X
key on the set is pressed:
>
FF
key on the remote commander is
>
rPLAY
key.
17