HP ProLiant DL380p User Manual page 88

Disconnect the SATA cable from the optical drive and the SATA connector on the system board. The
9.
optical bay is disabled with the chipset SATA cable option.
Connect the chipset SATA cable:
10.
Connect the chipset SATA cable connector to the chipset SATA controller port on the system board.
a.
The chipset SATA connector on the SATA cable is narrower than the chipset SATA controller port
header on the system board.
Connect the remaining chipset SATA cable connector to the SATA header on the hard drive cage.
b.
Coil the cables behind the hard drive backplane to minimize airflow impact.
11.
Install the fan cage
12.
Install the air baffle
13.
Install the PCI riser cage (on page 28), if removed.
14.
Secure any full-length PCI expansion boards with the retaining latch on the air baffle
15.
full-length expansion board
Install the access panel (on page 23).
16.
("Remove the hot-plug fan
("Remove the air baffle" on page 30).
retainer" on page 29).
cage" on page 24).
("Secure the
Cabling 88