Are Both Drive Module Leds Off (Online/Activity And Fault/Uid); Is The Drive Module Fault/Uid Led Blinking Amber; Is A Connected Host Port's Host Link Status Led Off - HP StorageWorks 2000fc - G2 Modular Smart Array User Manual

Are both drive module LEDs off (Online/Activity and Fault/UID)?

Answer
Yes

Is the drive module Fault/UID LED blinking amber?

Answer
No, but the
Online/Activity LED is
blinking.
Yes, and the
Online/Activity LED is off.
Yes, and the
Online/Activity LED is
blinking.

Is a connected host port's Host Link Status LED off?

Answer
No
Yes
Possible Reasons
• There is no power.
• The drive is offline.
• The drive is not configured.
Possible Reasons
The drive is rebuilding.
The drive is offline. A predictive
failure alert may have been
received for this device.
The drive is active, but a
predictive failure alert may have
been received for this device.
Possible Reasons
System functioning properly.
The link is down.
HP StorageWorks 2312fc and 2324fc Modular Smart Array user guide
Actions
• Check that the drive is fully inserted
and latched in place, and that the
enclosure is powered on.
Actions
No action required.
NOTE: Do not remove a drive that is
rebuilding. Removing a drive might
terminate the current operation and
cause data loss.
• Check the event log for specific
information regarding the fault.
• Isolate the fault.
• Contact an authorized service
provider for assistance.
• Check the event log for specific
information regarding the fault.
• Isolate the fault.
• Contact an authorized service
provider for assistance.
Actions
No action required.
• Check cable connections.
• Reseat cables.
• Replace cables.
• In SMU, review the event logs for
indicators of a specific fault in a
host data path component.
45