Using Free-Motion Open Toe Quilting Foot "O - Brother Innov-ís 2500D Operation Manual

c
Select any of the following stitches.
→ Free-motion quilting foot "C" is indicated in the
upper-left corner of the screen.
d
Remove the presser foot holder.
e
Attach free-motion quilting foot "C" at the
front with the presser foot holder screw
aligned with the notch in the quilting foot.
a
Presser foot holder screw
b
Notch
Note
Make sure that the quilting foot is attached properly
and not slanted.
f
Hold the quilting foot in place with your right
hand, and tighten the presser foot holder
screw using the screwdriver with your left
hand.
a
Presser foot holder screw
• Be sure to tighten the screw securely with the
screwdriver. Otherwise, the needle may touch the
quilting foot, causing it to bend or break.
g
Lower the feed dog position switch to
lower the feed dogs.
a
Feed dog position switch
6
a
b
CAUTION
a
h
Use both hands to stretch the fabric taut, and
then move the fabric at a consistent pace in
order to sew uniform stitches roughly
2.0-2.5 mm (approx. 1/16 - 3/32 inch) in length.
a
Stitch
i
Press to cancel the free-motion sewing
mode.
Memo
Do not be discouraged with your initial results. The
technique requires practice.
■ Using Free-motion Open Toe Quilting Foot
"O"
The free-motion open toe quilting foot "O" is used
for free-motion quilting with zigzag or decorative
stitches or for free-motion quilting of straight lines
on fabric with an uneven thickness. Any stitch can
be sewn with the free-motion open toe quilting foot
"O".
Free-motion open toe quilting foot "O"
Note
Free-motion open toe quilting foot "O" can also be
used with the straight stitch needle plate. We
recommend using free-motion open toe quilting foot
"O" with free-motion sewing of fabrics of uneven
thicknesses.
Memo
to
In order to sew with a balanced tension, it may be
necessary to adjust the upper thread tension. Test with
a sample piece of quilting fabric.