Brother Innov-ís 2500D Operation Manual page 8

a
Press to set the machine to free-motion
sewing mode.
→ The key appears as
raised to the necessary height for free-motion
sewing.
b
Select a stitch.
→ Free-motion open toe quilting foot "O" is indicated
in the upper-left corner of the screen.
Note
If using straight stitch needle plate with the free-motion
open toe quilting foot "O" then the letter "C" will be
indicated in the upper-left corner of screen.
, and the quilting foot is
c
Remove the presser foot holder.
d
Attach free-motion open toe quilting foot "O"
by positioning the pin of the quilting foot
above the needle clamp screw and aligning
the lower-left of the quilting foot and the
presser bar.
3
a
Pin
b
Needle clamp screw
c
Presser bar
Note
Make sure that the quilting foot is attached properly
and is not slanted.
e
Hold the quilting foot in place with your right
hand, and tighten the presser foot holder
screw using the screwdriver with your left
hand.
a
Presser foot holder screw
CAUTION
• Be sure to tighten the screw securely with the
screwdriver. Otherwise, the needle may touch the
quilting foot, causing it to bend or break.
f
Use both hands to stretch the fabric taut, and
then move the fabric at a consistent pace in
order to sew uniform stitches roughly
2.0-2.5 mm (approx. 1/16 - 3/32 inch) in length.
a
Stitch
g
Press to cancel the free-motion sewing mode.
Memo
Do not be discouraged with your initial results. The
technique requires practice.
1
2
7