Intel D915GVWB Product Manual page 58

Intel Desktop Board D915GVWB Product Guide
Table 10. BIOS Error Messages (continued)
Error Message
A: Drive Error
B: Drive Error
CMOS Battery Low
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
Checking NVRAM.....
Update OK!
Updated Failed
Keyboard Is Locked
Keyboard Error
KB/Interface Error
Memory Size Decreased
Memory Size Increased
Memory Size Changed
No Boot Device Available
Off Board Parity Error
On Board Parity Error
Parity Error
NVRAM / CMOS / PASSWORD
cleared by Jumper
<CTRL_N> Pressed
58
Explanation
No response from the diskette drive.
The battery may be losing power. Replace the battery soon.
The display type is different than what has been stored in CMOS.
Check Setup to make sure type is correct.
The CMOS checksum is incorrect. CMOS memory may have been
corrupted. Run Setup to reset values.
CMOS values are not the same as the last boot. These values
have either been corrupted or the battery has failed.
The time and/or date values stored in CMOS are invalid. Run
Setup to set correct values.
Error during read/write test of DMA controller.
Error occurred trying to access diskette drive controller.
Error occurred trying to access hard disk controller.
NVRAM is being checked to see if it is valid.
NVRAM was invalid and has been updated.
NVRAM was invalid but was unable to be updated.
The system keyboard lock is engaged. The system must be
unlocked to continue to boot.
Error in the keyboard connection. Make sure keyboard is
connected properly.
Keyboard interface test failed.
Memory size has decreased since the last boot. If no memory was
removed, then memory may be bad.
Memory size has increased since the last boot. If no memory was
added, there may be a problem with the system.
Memory size has changed since the last boot. If no memory was
added or removed, then memory may be bad.
System did not find a device to boot.
A parity error occurred on an offboard card. This error is followed
by an address.
A parity error occurred in onboard memory. This error is followed
by an address.
A parity error occurred in onboard memory at an unknown
address.
NVRAM, CMOS, and passwords have been cleared. The system
should be powered down and the jumper removed.
CMOS is ignored and NVRAM is cleared. User must enter Setup.