Intel Desktop Boards D865PCD Product Guide
Main Memory
NOTE
To be fully compliant with all applicable Intel
board should be populated with DIMMs that support the Serial Presence Detect (SPD) data
structure. If your memory modules do not support SPD, you will see a notification to this effect on
the screen at power up. The BIOS will attempt to configure the memory controller for normal
operation.
The desktop board supports system memory as defined below:
•
Dual channel and up to four 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory
Module (DIMMs) connectors with gold-plated contacts.
•
Supported memory configurations are:
Memory Speed
DDR333
DDR266
•
Support for:
Unbuffered, non-registered DIMMs
Serial Presence Detect (SPD) memory only
Support for Suspend to RAM (STR), S3 ACPI state
Non-ECC DDR
2.5 V memory
Related Links
Go to the following links or section in this manual for more information about:
•
The latest list of tested memory,
•
SDRAM specifications,
•
Installing memory, page 30 in Chapter 2
16
Processor
Pentium 4 processor
Pentium 4 processor or
Celeron processor
Pentium 4 processor
Celeron processor
http://support.intel.com/support/motherboards/desktop/
http://www.intel.com/technology/memory/pcsdram/spec/
®
SDRAM memory specification addendums, the
Front Side Bus
Memory Speed
Frequency
Outcome
533 MHz
400 MHz
533 MHz or 400 MHz
400 MHz
333 MHz
266 MHz
266 MHz
266 MHz