Table of Contents
Advertisement
6. SOFTWARE REFERENCE
6.11 Double Bytes OS/2 Warp
6.11.1 Driver Files
The enclosed SiS 5597/5598 Double Byte OS/2 3.0 driver contains the following files:
SETUP.CMD
SVGA.EXE
S768256.DL@
OTHERS
6.11.2 Installation
Due to some limitations in Double Byte OS/2 Warp, the installation process is a
two-phased.
1st phase: copy files, modify "config.sys", create "SiS Install" icon then shutdown
and re-boot OS/2.
2nd phase: double click the "SiS Install" icon to complete the installation
Before install SiS 5597/5598 OS/2 drivers, make sure:
1. Install your OS/2 system using "VGA display" option (i.e., standard VGA).
2. Start your OS/2 system.
Install SiS 5597/5598 OS/2 Warp drivers as following procedures:
1st phase
1. Enter "OS/2 window" or "OS/2 full screen".
2. Change to the directory where the SiS 5597/5598 OS/2 3.0 display drivers are
located and type SETUP <Enter>.
For example, A:\OS2\DBCS.30>SETUP
3. All the Driver Files will be copied to a subdirectory C:\SISDRV and an "SiS
Install" icon would be created.
4. After completing setup, shutdown and reboot OS/2.
2nd phase
5. After rebooting OS/2, double click the "SiS Install" icon. The "SiS Install"
icon would then be executed automatically and "Select Screen parameters for
SiS SVGA" screen would appear on the screen.
6. Select the desired resolution (and color) and frame rate from this screen, then
click OK to complete installation. An "SiS Setup" icon would be created for
future change modes and frame rate usage.
7. After completing installation, shutdown and reboot OS/2 (your settings will
only take effect when you reboot OS/2).
96
SiS driver install program
SiS PMI Generator
SiS IBMDEV32.DLL Display Driver
other files required during installation
ASUS SP98-N User's Manual
Advertisement
Table of Contents
