Setting Amount Of Rinse Aid; Switching Off Rinse Aid Refill Indicator; Utensils; Not Suitable - Bosch SPS53E12GB Operating Instructions Manual

en

Utensils

3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from
: to : . Please set rinse aid on
: to obtain very good drying results
( : is already set in factory).
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes
and the digital display )" displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
display )".
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to : (off).
2. Press START button P.
The set value is saved.
12
.
has been
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator h is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse aid" and set the
value to :
The rinse aid refill indicator h is now
switched off.
Utensils
l s U t e n s i

Not suitable

Cutlery and utensils made of wood.
Delicate decorative glasses, craft
and antique utensils. These decors
are not dishwasher-proof.
Plastic parts not resistant to heat.
Copper and tin utensils.
Utensils which are soiled with ash,
wax, lubricating grease or ink.
Aluminium and silver parts have a
tendency to discolour and fade during
the wash cycle. Even some types of
glass (e.g. crystal glass objects) may
turn cloudy after many wash cycles.
.