Storage - Stamina 15-0201 Owner's Manual

STORAGE

1. To store the INTONE® Folding
2. To avoid damage to the electronics, remove the battery before storing the INTONE® Folding
for one year or more.
Pro
3. To move the INTONE® Folding
and use the wheels on the REAR STABILIZER(3).
Cycle Pro
4. The minimum folded dimensions of the INTONE® Folding
long x 26.2 inches wide x 57.5 inches tall. Please measure your INTONE® Folding
dimensions are needed.
5. Follow the illustrated process below to fold the INTONE® Folding
a. Remove the PULL PIN(48). Fold the BACK SUPPORT(6) forward. Insert the PULL PIN(48) back
into the BACK SUPPORT(6) after folding.
b. Remove the BALL PIN(47) from the REAR FRAME(2). Fold the REAR FRAME(2) close to the MAIN
FRAME(1) and lock it in folded position with the BALL PIN(47).
Make sure the BALL PIN(47) goes through the holes on both sides of the REAR FRAME(2)
NOTE:
and the tube on the MAIN FRAME(1).
A
NOTE: When you fold the INTONE® Folding
of the METER(26) as described in the steps above and as shown in illustration C, there is no
need to readjust your seat height or meter angle before your next workout. You can fold your
INTONE® Folding
c. Loosen and pull the ADJUSTMENT KNOB(41), then lower the SEAT FRAME(5) to the lowest position.
Lock the SEAT FRAME(5) into position by releasing and retightening the ADJUSTMENT KNOB(41).
Swing the METER(26) down toward the floor as shown in illustration D.
C
, simply keep it in a clean dry place.
Cycle Pro
, Hold the HANDRAIL(7) to move the INTONE® Folding
Cycle Pro
Cycle Pro
smaller by following the next step.
Cycle Pro
Cycle Pro
Cycle Pro
without changing the seat height or the angle
13
are approximately 23.2 inches
Cycle Pro
.
Cycle
if exact
B
D