Using The Minimon For Signal Distribution In Simple P.a. Applications - Behringer MINIMON MON800 User Manual

11
MINIMON MON800 User Manual
◊
The speaker outputs of the MINIMON provide line-level
signals. Passive loudspeaker systems must be connected via
an external integrated amplifier. Active loudspeakers have
an amplifier built in and can therefore be connected directly
to the MINIMON outputs.
The two headphones connectors
mix with a pair of headphones or route a monitor signal to one of the
musicians. If you want to record several musicians, use the CUE OUT jack
for the connection of a headphones amp (e.g. BEHRINGER MINIAMP
(19)
AMP800). In this way, each musician can set the volume of his
headphones separately on the headphones amplifier.
Using a footswitch connected to the TB jack
back microphone and route the microphone signal to the monitor paths.
A recording device, such as a DAT or CD recorder, can be connected to
the 2-TRACK OUT outputs .
(20)
SPEAKERS
OUT A
MINIMON MON800
MIX IN A
MD player
Fig. 4.2: Using the MON800 for signal distribution in small P.A. systems
and allow you to check your
(3) (15)
you can activate the talk-
(16)
MONITOR
SPEAKERS
1C-BK
EUROPOWER
EP2000
PHONES
HPM1000
4.2 Using the MINIMON for signal
distribution in simple P.A. applications
The MINIMON can also be used for small P.A. systems,
for example, in cafés and galleries. In this case, the three loudspeaker
outputs and can be used for three pairs of speakers set up
(17) (18)
in several rooms. The inputs C and D
connected directly to consumer equipment, such as CD/MD/
cassette players or a radio tuner. If necessary, the built-in talk-back
microphone allows you to make announcements for your guests.
(11)
With an additional set of headphones you can pre-listen to the input
signals you wish to play back via the audio system. The following
illustrations shows a possible wiring scheme.
SPEAKERS
OUT B
CD/TAPE
IN C
Casette tape player
of the MINIMON can be
(21)
MONITOR SPEAKERS MS16
SPEAKERS
OUT C
CD/TAPE
IN D
CD player