HP SN3000B Quick Start Instructions page 2

One accessory kit with the following items:
Rack Mount Kit, including rails, rail mounting
◦
hardware, and plenum
HP product documentation, including Read
◦
Me First, Safety Guides, End User License
Agreement and Warranty
Two power cords
SN3000B 16Gb 24-port FC switch
Figure 2 (page 2) shows the port side of the 24-port
switch.
Figure 2 Port side of the 24-port switch
1. System status LED
2. Management Ethernet port
with LEDs
3. USB port
4. FC ports (0-3)
Verify the SN3000B 16Gb 24-port FC
switch carton contents
Verify that the carton contains the following (any SFPs
ordered will not be in this carton; they will be
packaged separately):
One HP SN3000B 16Gb 24-port FC Switch with
one integrated power supply/fan assembly
Rubber feet, required to set up the switch as a
standalone unit
Serial cable with an RJ-45 connector plus an
adaptor for RJ-45 to DB9
HP SAN Network Advisor DVD
Brocade EZ Switch and China ROHS
documentation
One accessory kit with the following items:
◦ Rack Mount Kit, including rails, rail mounting
hardware, and plenum
◦ HP product documentation, including Read
Me First, Safety Guides, End User License
Agreement and Warranty
One power cord
5. System power LED
6. Serial console port
7. Switch ID pull-out tab
8. FC ports (4–7)
NOTE: The HP SN3000B 16Gb Fibre Channel
Switch can, as an option, be configured with a
second power supply/fan assembly, which must
be ordered separately.
Verify the SN6000B and SN3000B 16Gb
FC Switches installation requirements
To set up the switch for the first time, you will need the
following:
Workstation with an installed terminal emulator
(such as HyperTerminal)
Unused IP address and corresponding subnet
mask and gateway address
Serial cable (supplied with the switch)
Ethernet cable
Access to an FTP server, SCP server, or USB
device for backing up the switch configuration
(optional)
HP B-series SFP+ transceivers and compatible
cables (HP B-series 16 Gb/s SFP+ transceivers
required for 16 Gb/s performance), as required
IMPORTANT:
separately. The HP SN6000B and SN3000B
16Gb FC Switches support only transceivers
and cables labeled B-series SFP+, or B-series
cable. See the compatibility matrix at
hpsancompat.com/
supported transceivers.
Plan the SN6000B and SN3000B 16Gb
FC Switches site environment
To ensure adequate cooling, install the switch with the
nonport side (which contains the air intake vents)
facing the cool-air aisle. Verify that the ambient air
temperature does not exceed 40°C (104°F) and that
the ambient humidity remains between 10% and 85%
while the switch is operating.
NOTE: You must install the plenum if the switch
is to be installed in a rack.
Page 2
Order transceivers or cables
http://
for more information on