Cf_Fanmode Command; Cf_Fancontrol Command; Cf_Filtimer Command; Cf_Filh Command - Sanyo PLC-XU106 - 4500 lm Manual

PLC-XU106 Expand Serial Command Functional Specifications

8.10.21 CF_FANMODE Command

Command "CF_FANMODE_%1"[CR]
"L1" ---------------------------- Set Fan Mode to L1
%1
"L2" ---------------------------- Set Fan Mode to L2
Switch Fan Mode.
(Available in normal Power ON status only).
When L1 is selected, fan noise after POWER OFF is louder.
Details When L2 is selected, fan noise after POWER OFF becomes quiet, however, fan
rotates longer than L1.
The status set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
Acceptable
Response
Unacceptable

8.10.22 CF_FANCONTROL Command

Command "CF_FANCONTROL_%1"[CR]
"OFF" ---------------------------- Set Fan control to Off
"ON1" ---------------------------- Set Fan control to On1
%1
"ON2" ---------------------------- Set Fan control to On2
"ON3" ---------------------------- Set Fan control to On3
Set Fan control setting.
The status set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
(Available in normal Power ON status only).
Acceptable
Response
Unacceptable

8.10.23 CF_FILTIMER Command

Command "CF_FILTIMER_%1"[CR]
"100" -------------------- Set 100 hours
"200" -------------------- Set 200 hours
"300" -------------------- Set 300 hours
%1
"OFF" ------------------- No warning display
"UP" --------------------- Switch Filter timer forward (Off →100 → 200 → 300 → Off)
"DN" --------------------- Switch Filter timer backward(Off → 300 → 200 → 100...)
Details Set timer of Filter replacement /clean-up warning display.
Acceptable
Response
Unacceptable

8.10.24 CF_FILH Command

Command "CF_FILH_%1"[CR]
%1 "RST" ---------------Reset Filter used time
Details Reset filter used time
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
40 / 68