Turning Off The Projector; Focusing And Zooming Your Image; Adjusting The Height Of Your Image - Epson RB-V11H255020-N - PowerLite 83c LCD Projector Product Information Manual

PowerLite 822p/83c Projector

Turning Off the Projector

When you've finished using the projector, follow the
recommended procedure to shut it down.
Note:
When sleep mode is enabled and the projector has not received any
input signals for the number of minutes specified in the Extended
menu (from 1 to 30), the projector automatically turns off the lamp
and enters "sleep mode." This conserves electricity, cools the
projector, and extends the life of the lamp. If you are done using the
projector, unplug the power cord. If you want to start projecting
again, plug it in and press the P
sleep mode on or off through the Extended menu.
1. If you're using a computer, shut it down first; otherwise you
may not be able to see your computer's display to shut it
down properly.
2. To turn off the projector, press the P
projector or remote control.
You see this confirmation
message: (If you don't want
to turn it off, press any other
button or wait a few seconds
until it disappears.)
3. Press the P button again. The projector beeps
Power
twice, the lamp is turned off, and the P
orange.
Note:
With Epson's exclusive Instant Off
down period, so you can pack up and go immediately after
turning off the projector.
(If you want to turn the projector on again, press the
button.)
Power
P
4. Press up on the blue foot release lever and lower the
projector to retract the front adjustable foot, if necessary.
5. Close the slide.
A/V Mute
6. Unplug the power cord.
7. Turn off and disconnect any
equipment plugged into the
projector.
Caution:
To avoid damaging the projector or lamp, never unplug the
power cord when the power light is green or flashing orange.
8. If you won't be using the projector for awhile, store it in a
protective case.
6 PowerLite 822p/83c Projector
-
button. You can turn
Power
button on the
Power
light turns
Power
®
technology there's no cool-
Adjusting the Image and Presentation
The following sections describe how to adjust the image and
control your presentation.

Focusing and Zooming Your Image

Rotate the focus ring to sharpen the image, and the zoom ring
to reduce or enlarge the image.
You can also change the image size by moving the projector
closer to or farther away from the screen. You can use the
buttons on the remote control to zoom in on a portion
E-Zoom
of the image. See page 8 for instructions.

Adjusting the Height of Your Image

If the image is too high or low, you can correct it by adjusting the
projector's front foot.
1. Stand behind the projector. Press up on the blue foot release
lever and lift the front of the projector to extend the front
adjustable foot.
2. Once the image is positioned where you want, release the
lever to lock the foot in position.
When the Auto Keystone feature is enabled in the Settings
menu, the projector automatically corrects images that are
distorted when the projector is tilted up (up to a 30° tilt). The
Keystone window appears on the screen while the projector
makes the correction. If the projected image still isn't
rectangular, follow the instructions in the next section.
3/08
Focus
Zoom