Oki OKIPAGE14e User Manual page 36

Symptom: Print job started with italics, changed to
bold, but italics still output.
Problem: Font selection is by priority, and italic is
"higher" than bold.
Solution: Turn italics off before turning bold on.
Symptom: Printer ignores control codes sent prior to
printing a document.
Problem: The application software automatically sends
a reset command before printing.
Solution: Embed the control codes in the text to be
printed.
Symptom: "Garbage" prints out.
Problem: Incorrect driver is installed.
Solution: Install an appropriate driver.
Symptom: Printer's output is below rated speed.
Problem: Delays are caused by software formatting
routines, graphics downloads, and other application
specific factors.
Solution: For maximum speed, output plain text.
|
E-36 OKIPAGE 14e
Symptom: Size of top margin increases with each
page printed.
Problem: "Creeping text." Number of lines per page
in software is not equal to number of lines per
page of printer.
Solution: Many software packages assume 66 lines
per page, but your printer's default is 60. Adjust
software accordingly, or set LINES/ Pg in Menu 1 to
equal lines per page in software.
Problem: In Epson FX Emulation, when command for
66 lines is sent to the printer, printer prints only 64
lines on a page, looses the 65 and 66 line and
prints 67 th line on the second page.
Solution: Set line spacing to 35/216 with a software
command ESC "3" Pn (Pn=number of 216ths).
Then send the command to set the page length to
66 lines per page, ESC C Pn (Pn = number of lines
per page).
Symptom: Strange symbols appear during normal
printing.
Problem: Wrong symbol set.
Solution: Make sure the symbol set selected
corresponds to symbol set resident, or in soft font.