2.
Marvell
Serial ATA 6.0 Gb/s connectors
®
(7-pin SATA_6G_1, 7-pin SATA_6G_2 [gray])
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA 6.0 Gb/s
hard disk drives.
•
•
•
2-30
These connectors are set to Standard IDE mode by default. In Standard IDE mode,
you can connect Serial ATA data hard disk drives to these connectors.
You must install Windows
®
hard disk drives.
When using hot-plug and NCQ, set the Marvell 9123 Controller item in the BIOS to
[AHCI Mode]. Refer to section 3.6.3 Onboard Devices Configuration for details.
XP Service Pack 2 or later versions before using Serial ATA
Chapter 2: Hardware information