ASROCK K10N7SLI Installation Manual page 6

Nvidia raid

Hide thumbs Also See for K10N7SLI:

Table of Contents

STEP 4: Use "RAID Installation Guide" to set RAID configuration.

Before you start to configure RAID function, you need to check the RAID installation

guide in the Support CD for proper configuration. Please refer to the BIOS RAID

installation guide part of the document in the following path in the Support CD:

.. \ RAID Installation Guide

STEP 5: Install Windows

After step 1, 2, 3, you can start to install Windows

system. At the beginning of Windows

driver. When prompted, insert the SATA / SATAII driver diskette containing the NVIDIA

RAID driver. After reading the floppy disk, the drivers will be presented. Select the drivers

to install. The drivers are as below:

A. NVIDIA RAID Driver (required)

B. NVIDIA nForce Storage Controller (required)

Please select A and B for Windows

drivers needed for RAID mode, you have to select them separately. Please specify the

first RAID driver and then specify again for the second one.)

NOTE. If you install Windows

(create, convert, delete, or rebuild) RAID functions on SATA / SATAII HDDs, you still

need to set up "SATA Operation Mode" to [RAID] in BIOS first. Then, please set the

RAID configuration by using the Windows RAID installation guide part of the

document in the following path in the Support CD:

.. \ RAID Installation Guide

XP / XP 64-bit OS on your system.

XP / Windows

setup, press F6 to install a third-party RAID

XP / XP 64-bit in RAID mode. (There are two RAID

XP / Windows

XP 64-bit on IDE HDDs and want to manage

XP 64-bit OS on your

Table of Contents