ASROCK K10N78M Installation Manual page 6

STEP 3: Set Up BIOS.
A. Enter BIOS SETUP UTILITY
B. Set the "SATA Operation Mode" option to [RAID].
STEP 4: Use "RAID Installation Guide" to set RAID configuration.
Before you start to configure RAID function, you need to check the RAID installation
guide in the Support CD for proper configuration. Please refer to the BIOS RAID
installation guide part of the document in the following path in the Support CD:
.. \ RAID Installation Guide
®
STEP 5: Install Windows
You can start to install Windows
beginning of Windows setup, press F6 to install a third-party RAID driver. When prompted,
®
insert the SATA / SATAII driver diskette containing the NVIDIA
the floppy disk, the drivers will be presented. Select the drivers to install. The drivers are
as below:
A. NVIDIA RAID Driver (required)
B. NVIDIA nForce Storage Controller (required)
Please select A and B for Windows
drivers needed for RAID mode, you have to select them separately. Please specify the
first RAID driver and then specify again for the second one.)
NOTE. If you install Windows
(create, convert, delete, or rebuild) RAID functions on SATA / SATAII HDDs, you still
need to set up "SATA Operation Mode" to [RAID] in BIOS first. Then, please set the
RAID configuration by using the Windows RAID installation guide part of the
document in the following path in the Support CD:
.. \ RAID Installation Guide
Advanced screen
XP / XP 64-bit OS on your system.
XP / Windows XP 64-bit OS on your system. At the
® ®
XP / XP 64-bit in RAID mode. (There are two RAID
®
XP / Windows XP 64-bit on IDE HDDs and want to manage
® ®
6 6 6 6 6
IDE Configuration.
RAID driver. After reading
®