Events; Event Servers; Event Types - Axis M3011 User Manual

Events

Pre-defined parameters, known as an event or Event Type can trigger certain actions in the camera. A common event type is
an alarm that causes the camera to upload images. Many event types use an Event Server, to receive uploaded images.
An event that is triggered by a signal, such as a door switch, motion detection, or system event, is called a triggered event, see
page 20.
A scheduled event runs at pre-programmed times.
An Action refers to what happens when the event occurs.
This section describes how to configure the camera to perform certain actions when events occur.

Event Servers

Event Servers are used to receive uploaded image files and/or notification messages. To set up Event Server connections in
your camera, go to Setup > Events > Event Servers and enter the required information for the required server type.
Server type Purpose
• Receives uploaded images
FTP Server
• Receives notification messages
HTTP Server
• Receives uploaded images
• Receives notification messages
TCP Server
For details on each setting, see the online help
When the setup is complete, the connection can be tested by clicking the Test button (the connection test takes
approximately 10 seconds).

Event Types

An Event Type describes how and when the camera performs certain actions.
Example:
If somebody passes in front of a camera and an event has been configured to detect and respond to motion,
the camera can record and saves images to an FTP server, and can send a notification e-mail to an e-mail address. Images
can be sent as e-mail attachments.
Information required
• Descriptive name of your choice
• Network address (IP address or host name)
• User Name and Password
• Descriptive name of your choice
• URL (IP address or host name)
• User Name and Password
• Descriptive name of your choice
• Network address (IP address or host name)
• Port number
available from each web page.
19
AXIS M3011 - Events