Table of Contents
Advertisement
90539499 01 EM100B.qxd
7/7/08
06 PROGRAM DIGITAL DISPLAY -
P OWER FACTOR, BILLING MODE
T E M P E R AT U R E ,
S T E P
A C T I O N / P R E S S
Set day of the week.
Set temperature units.
Find your Power Factor (the number you recorded in
section 03 Installing Your Meter Sensor).
Enter your Power Factor.
Typical Power
Factors are:
7 .2 for electromechanical meters
1.0 for electronic meters with
optical ports
Enter your Billing Mode:
TIER
for Flat or Tiered rates
2-PEAK
for Time-of-Use with two rates
3-PEAK
for Time-of-Use with three rates
If your billing mode is Flat Rate, p roceed to section 07 .
If your billing mode is T i e red Rate, p roceed to section 08.
If your billing mode is Time-of-Use Rate, p roceed to section 09.
28
10:05 AM
Page 28
TIME, DAY,
D I S P L AY
Power Factor =
(usually 7 .2 Kh)
07 PROGRAM DIGITAL DISPLAY – FLAT RATE BILLING
S T E P
A C T I O N / P R E S S
RECORD YOUR BILLING RATE HERE
Find the Billing Rate
you recorded in section 05.
Billing Rate: =
Enter your Billing Rate.
To make the numbers change
faster, you can press and hold
the
or
.
Do NOT enter a threshold.
Press the
button until you
see dashes appear on the
Digital Display.
Programming is complete!
Go to Section 10, Using Yo u r
Power Monito r.
D I S P L AY
¢/kWh
29
Hide quick links:
Advertisement
Table of Contents
