Table of Contents
Advertisement
90539499 01 EM100B.qxd
7/7/08
0 3 I N S TALLING YOUR METER SENSOR
TYPE 2—ELECTRONIC WITH OPTICAL PORT ON FAC E
A . Record Your Meter's Power F a c t o r
Find and re c o rd your mete r' s Power Fa c to r. On the face of the mete r, look for a number
p receded by the lette rs Kh, Ks, or Kt. This number is usually 1.0 for an electronic mete r. I f
your meter lists more than one of these nu m b e rs, look for the smallest nu m b e r. Wri te this
number in the box below. You will need it later (in section 06) when you pro gram your Digita l
D i s p l a y.
Optical Port
Power Factor
Optical
Port
Power Factor
Power Factor
Optical Port (left port)
10
10:05 AM
Page 10
Power Factor =
(usually 1.0 Kh)
Optical Port
Power
Factor
0 3 I N S TALLING YOUR METER SENSOR
TYPE 2—ELECTRONIC WITH OPTICAL PORT ON FAC E
B . Prepare Your Meter Sensor
Make sure the batteries are installed in the Meter
Sensor.
1.
Pull the Sensor A rm Latch Cover upwa rd to open it.
2 .
Ve rify that the Sensor A rm is pushed in as far as it
will go into the body of the Meter Sensor.
3 .
Close the Sensor A rm Latch Cove r.
4 .
Ve rify that the Sensor A rm is fully pushed in.
N o te : If the optical port is closer than 1.5 inches to the
edge of the glass housing, you will need to add a ru bb e r
shim to the Sensor.
If the port is fa rther than 1.5 inches from the edge, yo u
can skip steps 5-7 .
5 .
Peel off the adhesive backing from the shim.
6 .
Position the shim on the underside of the Mete r
Sensor with the adhesive side dow n .
7 .
Press the shim in place onto the underside of the
M e ter Sensor body.
Ruler
11
Hide quick links:
Advertisement
Table of Contents
