Panasonic TH-42LF30U Operating Instructions Manual page 45

Item
Off
You can set the power-on delay time of the displays to reduce the power load, when you press
on the multiple displays that are set together, for example, on MULTI DISPLAY system.
Set each display's setting individually.
Power ON Screen Off:
Delay 1 to 30 (sec.): Set the power-on delay time (second).
Notes:
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the power cord.
Off:
On:
The clock is displayed at the lower left of the screen when
Clock Display
Whether to show/hide No activity power off Precautions at the time of power ON is set.
Power On Message On:
(No activity power Off:
off) Note:
This setting is enabled only if "NO ACTIVITY POWER OFF" is "ENABLE" (see page 32).
Set the functions that operates when
Signal: The "SIGNAL" menu is displayed.
Screensaver: The "SCREENSAVER" menu is displayed.
ECO menu: The "ECO MODE SETTINGS" menu is displayed.
Set up TIMER: The "SET UP TIMER" menu is displayed.
Note:
Factory settings are as follows.
FUNCTION1 button: Signal
FUNCTION2 button: Screensaver
Function button assign 1
Function button assign 2
Use the FUNCTION button
Sets the lock setting for the display Power switch.
Power Switch Lock On:
Off:
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
"Shipping" menu is displayed and the lock is released when it disappears.
1 2 3.... 30
The display will be turned on at the same time as
After pressing
Not display the clock.
Display the clock.
Note: When "PRESENT TIME SETUP" is not set, the clock is not displayed even
10:00
The warning precautions are shown at the time of power ON.
The warning precautions are not shown at the time of power ON.
The menu screen is displayed. (Example: Signal)
SIGNAL
3D Y/C FILTER
COLOR SYSTEM
3 : 2 PULLDOWN
NOISE REDUCTION
Press the FUNCTION button to exit from the menu.
Power switch operation is disabled.
Power switch operation is enabled.
button on the remote control and hold for more than 5 seconds. The
Adjustments
, the display will be powered on with time delay depending on this setting.
if "Clock Display" is "On" (see page 28)
is pressed.
[ VIDEO ]
ON
AUTO
OFF
OFF
Options Adjustments
is pressed.
button is pressed.
to turn
45