Panasonic TH-42LF30U Operating Instructions Manual page 44

Options Adjustments
Item
Locks the input switch operation.
Off
* "SLOT INPUT" is displayed when an optional Terminal Board is installed.
Input lock
Notes:
• Only the adjusted signal is displayed (see page 17).
• Input switch can be used when this is set to "Off".
Off
Off: All the buttons on main unit can be used.
MENU&ENTER: Locks
On: Locks all the button on main unit.
Button lock
Sets Button lock with the unit buttons in the following procedure.
Off: Press
MENU&ENTER: Press
On: Press
Off
Off:
User1: You can only use
Remocon User level
User2: You can only use
User3: Locks all the buttons on remote control.
Enable:
Off-timer function Disable: Disables the "Off-timer function".
Note:
Normal
Sets the power mode of the unit for when the power recovers from failure or after plugging off and in again.
Normal: Power returns in as the same state as before the power interruption.
Initial Power Mode
Standby: Power returns in standby mode. (Power Indicator : red/orange)
On:
Note: When using multiple displays, "Standby" is preferred to be set in order to reduce a power load.
Sets panel ID number when panel is used in "Remote ID" or "Serial ID".
ID select Set value range: 0 - 100
(Standard value: 0)
The setting of this menu is valid only when using ID remote control.
Off:
On:
Remote ID
Note: To use the ID remote control function, it is necessary to set each ID number of remote control and
Sets the panel ID Control.
Serial ID Off:
On:
Sets the top and end of a daisy chain when the SERIAL terminal of Display is daisy chained.
---:
Serial Daisy Chain
Top:
End:
Off:
Studio W/B On:
Note: Valid only when the "WARM" is set as "COLOR TEMP" in PICTURE menu.
Off
Off:
Auto: Power is transmitted to the slot power only when main power is on.
Slot power
On:
Note: In some cases, power is transmitted to the slot power when main power is on or in the standby state
44
SLOT INPUT* VIDEO
On MENU&ENTER
MENU ENTER/
and
four times Press
ENTER/
four times Press
four times Press
User1 User2
You can use all of the buttons on the remote control.
, ,
button on the remote control.
Enables the "Off-timer function".
When "Disable" is set, the Off-timer is cancelled.
On Standby
Power returns in power On. (Power Indicator : green)
Disables ID remote control functions. You can use normal remote control operations.
Enable ID remote control functions.
display unit. About the setting method, please refer to "ID Remote Control Function" (see page 37)
and "ID select" (above-mentioned).
Disables external control by the ID.
Enables the external control by the ID.
When the Display is under SERIAL control on a standalone basis, or if not at the top or end of daisy
chain.
To connect to the top of daisy chain.
To connect to the end of daisy chain.
Nullify all the settings adjusted.
Sets the color temperature for TV studio.
Auto On
Power is not transmitted to the slot power.
Power is transmitted to the slot power when main power is on or in the standby state.
regardless of the slot power setting.
Adjustments
Component/RGB
buttons on main unit.
INPUT
four times Press four times Press
four times Press
ENTER/
four times Press four times Press
User3
, , buttons on the remote control.
PC DVI HDMI1
ENTER/
INPUT
four times Press
ENTER/
HDMI2 Off
ENTER/