Sony VPL-CW255 Operating Instructions Manual page 38

3
Loosen the 3 screws on the lamp then
pull out the lamp by its grab.
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
3 screws.
5
Close the lamp cover and tighten the
3 screws.
Note
Be sure to install the lamp and Lamp cover
securely as it was. If not, the projector
cannot be turned on.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
38
Replacing the Lamp
7
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the SET
SETTING menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer (page 25).
Grab
Caution
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the
Telecommunications Industry
Association (www.eiae.org).
notification of