Color Temperature Default; Daylight View; Noise Reduction; Tv-System - Panasonic PT-LB3U Operating Instructions Manual

Menu operation (continued)
▌ COLOR
You can adjust the color saturation of the projected
image. (For S-VIDEO/VIDEO/RGB (Moving image)/
YP P input signal only)
B R
Change
Lighter
setting
▌ TINT
You can adjust the skin tone of the projected image.
(For S-VIDEO/VIDEO/RGB (Moving image)/YP
input signal only)
Change
More reddish
setting
▌ SHARPNESS
You can adjust the sharpness of the projected image.
Change
Less sharp
setting
NOTE:
• The adjustable range depends on the input signal.
▌
WHITE BALANCE
You can adjust the white balance in 3-color
temperature. (For RGB (Still image) input signal only)
Change
-1
setting
Advanced menu item
WHITE BALANCE
WHITE BALANCE
WHITE BALANCE
▌

COLOR TEMPERATURE

You can adjust the white balance of the projected
image.
Change
Change setting
setting
DEFAULT Balanced white
HIGH More bluish
LOW More reddish
▌
You can keep the projected image bright and vivid even
in well-lit rooms where the ambient light sources cannot
be controlled.
Change
Change setting
Darker
setting
P
B R
NOTE:
• Do not cover the Ambient Luminance Sensor(ALS) of the
Change
projector, otherwise the AUTO mode may not function
More greenish
setting
properly.
• AUTO
PROJECTOR SETUP menu is set to REAR/DESK or
REAR/CEILING.
▌
You can switch the automatic noise reduction system
Change
More sharp
on/off. (For S-VIDEO/VIDEO input signal only)
setting
Change setting
NOTE:
• If
signal has less noise, the image may look different from the
Change
+1
true image. If so, set to OFF.
setting
▌
Default
Switch the setting manually to match the video data.
RED 0
(For S-VIDEO/VIDEO input signal only)
GREEN 0
BLUE 0
Change setting
SECAM
Change
NOTE:
Change setting
setting
AUTO
•
• When the projector is not working properly in
change the setting according to each TV system type.
AUTO
•
signal from NTSC/NTSC 4.43/PAL/PAL60/PAL-M/PAL-N/
SECAM.

DAYLIGHT VIEW

Change
setting
AUTO Automatic adjustment
ON Active
OFF Deactive
is not available when INSTALLATION in

NOISE REDUCTION

Change
setting
OFF No noise reduction
ON Automatic noise reduction
NOISE REDUCTION is set active when the selected input

TV-SYSTEM

Change
setting
AUTO NTSC
PAL-N
mode is selected by default.
setting will automatically select the compatible
Change
Change setting
setting
Change
Change setting
setting
Change
Change setting
setting
NTSC4.43
PAL-M PAL
AUTO mode,
ENGLISH  29