Hitachi CP-WX2515WN User Manual page 71

OPTION menu
Item
SERVICE
(continued)
(continued on next page)
62
COMMUNICATION TYPE
Select the communication type for transmission via
the CONTROL port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is selected as the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD (
SERIAL SETTINGS
Select the serial communication condition for the
CONTROL port.
BAUD RATE
COMMUNICATION
PARITY
(continued)
• The BAUD RATE is fixed to 19200bps
and PARITY is fixed NONE when the
COMMUNICATION TYPE is set to OFF (
TRANSMISSION METHOD
Select the transmission method for communication
by the NETWORK BRIDGE from the CONTROL
port.
HALF-DUPLEX: This method lets the projector
FULL-DUPLEX: This method lets the projector
• HALF-DUPLEX is selected as the default setting.
• If you select HALF-DUPLEX, check the setting of
the item RESPONSE LIMIT TIME (
Description
required to control an external device as a
network terminal, via this projector from the
computer.
The CONTROL port doesn't accept RS-232C
commands (Network Bridge Function in the
Network Guide)
commands using the CONTROL port.
4800bps 9600bps
NONE ODD
HALF-DUPLEX
make two way communication, but only one
direction, either transmitting or receiving data, is
allowed at a time.
make two way communication, transmitting and
receiving data at the same time.
19200bps
EVEN
FULL-DUPLEX
63).
below)
38400bps
above).