Table of Contents
Advertisement
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA2_0: see p.11, No. 10)
(SATA2_1: see p.11, No. 8)
(SATA2_2: see p.11, No. 12)
(SATA2_3: see p.11, No. 11)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.11 No. 15)
(9-pin USB8_9)
(see p.11 No. 16)
Print Port Header
AFD#
ERROR#
PINIT#
(25-pin LPT1)
(see p.11 No. 18)
1
SPD0
STB#
These four Serial ATAII
SATA2_3
SATA2_1
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATA2_2
SATA2_0
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This is an interface for print
port cable that allows
GND
SLIN#
convenient connection of printer
SPD7
devices.
SPD6
ACK#
SPD5
BUSY
SPD4
PE
SPD3
SLCT
SPD2
SPD1
23
Advertisement
Table of Contents
