3. Disconnect all wires and cables from the paddle card and lift out.
Hard disk drive
To remove the hard disk drive do the following:
1. Turn off the computer and peripheral devices and disconnect all external cables
2. Remove the CD/diskette drive tray. See"Accessing system board components"
3. Remove the 3 screws holding the hard disk tray and remove.
4. Disconnect all hard disk drive wires.
5. Remove the 4 screws attaching the hard disk to the hard disk tray.
Removing the center beam
To remove the center beam do the following:
34
Hardware Maintenance Manual
and power cords; then remove the cover. See "Removing the cover" on page 20.
on page 21.
Note: When replacing the hard disk drive make sure you obtain the proper
Recovery CD to install after you install the new hard drive.