Table of Contents
Advertisement
Product Recovery Program menu
Type 6290 machines have recovery and diagnostics programs on a separate hard
drive partition. The Enhanced Diagnostics diskette is not shipped with the
machine. To download the Diagnostics program see "Diagnostics program
download" on page 12.
At startup the machine displays the following prompt:
To start the Product Recovery Program press F11
Attention: Make sure all data is backed up to avoid loss when the Product
Recovery program is used.
After depressing F11 you are given the following options.
v Factory Contents
v System utilities
This utility reformats the hard drive and restores all original files.
1. Repair (Windows NT 4.0 and 2000 Only)
This runs the Windows NT 4.0 emergency repair utility.
2. Run Diagnostics
Runs the IBM Enhanced Diagnostic Program.
3. Create a Diagnostics Diskette
Creates a bootable diagnostic diskette.
4. System Information
Displays information about your computer configuration and allows the user
to gather system information that would be needed during a Help Center
call.
5. Create Recovery/Repair Diskette (Disk to Disk Solution Only)
Creates a startable diskette to restore access to the IBM Product Recovery
program on the hard disk.
6. Recovery CD
In the event of a Hard Disk Drive failure a Recovery CD can be used to
restore the Hard Disk Drive to the original factory preset. Be sure to use the
Recovery CD FRU list to obtain the proper recovery CD for the computer
model you are servicing.
11
Chapter 4. Diagnostics
Advertisement
Table of Contents
