Ventilation Requirements - NEC MultiSync X401S User Manual

3. Using Wall Mount Adapter
If the mounting accessory interferes with the option board,
ventilation hold or speaker attachment hole, use the included
wall mount adaptors and screws. If the adaptor screws are
too long, include a washer to reduce the depth. Washer not
included.
Wall mount adapter
Unit
10-12 mm
Pictured mounting solutions may not be available in all
countries.
4. Installing and removing optional table
top stand
CAUTION: Installing and removing the stand must be done
by two or more people.
To install, follow those instructions included with the stand or
mounting apparatus. Use only those devices recommended
by the manufacturer.
NOTE: For X462S/X552S, use ONLY thumbscrews which
are included in the monitor. For X401S, use ONLY
thumbscrews which are included with the optional
table top stand.
When installing the LCD monitor stand, handle the unit with
care to avoid pinching your fi ngers.
Optional table top stand
Table
Mounting bracket
Washer
Wall mount
adapter screw
250 mm (X401S)
265 mm (X462S/X552S)
Protective Sheet
English-7
NOTE: Install the stand so the long end of the feet face
forward. Use the ST-322 for the X401S, the
ST-4020 for the X462S and the ST-5220 for the
X552S.

5. Ventilation Requirements

When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the enclosure
to allow heat to disperse, as shown below.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and mounting apparatus; especially when you use
monitors in multiple screen.
NOTE: The sound quality of the internal speakers will
differ according to the acoustics of the room.
6. Prevent Tipping
When using the display with the optional table top stand
fasten the LCD to a wall using a cord or chain that can
support the weight of the monitor in order to prevent the
monitor from falling. Fasten the cord or chain to the monitor
using the provided clamps and screws.
For the X401S, the clamps and screws are included with the
optional table top stand.
295 mm
Screw Holes
Clamp
Screw (M4)
Before attaching the LCD monitor to the wall, make sure that
the wall can support the weight of the monitor.
Be sure to remove the cord or chain from the wall before
moving the LCD.
Cord or chain