Removing Or Replacing The Service Door; Removing The Service Door - HP ProBook 4340s Getting Started Manual

Removing or replacing the service door

CAUTION:
Save your work and shut down the computer before adding or replacing a memory module or hard
drive.
If you are not sure whether the computer is off or in Hibernation, turn the computer on by pressing the
power button. Then shut down the computer through the operating system.

Removing the service door

Remove the service door to access the memory module slot, hard drive, regulatory label, and other
components.
To remove the service door:
1. Remove the battery (see
2. With the battery bay toward you, remove the security screw (1) (if the security screw is being
used). For additional information about the security screw, see
on page
3. Slide the service door release latches (2) to release the service door.
NOTE:
one at a time.
4. Slide the service door towards the front of the computer (3) and then lift it (4) away from the
computer.
36 Chapter 5 Maintenance
To prevent information loss or an unresponsive system:
Inserting or removing the battery on page
35.
You can slide the service door release latches simultaneously or you can slide them
33).
Using the optional security screw