Lexmark T656 Technical Reference Manual page 27

Field Name Type
Esc(s#1,#2,#3,#4S int
Esc(s#P int
Notes:
• The default V parameter observed for the HP BarDIMM Pro ver 3.3A is:
– Standard: 32 (11mm)
– Truncated: 12 (4mm)
– Stacked: 13 (4mm total height)
– Limited: 10 (3mm)
• Some of the Forms and Bar Code Card default V parameter values (in the above table) are
slightly different than HP, and match the RSS-14 AIM specification values.
• Each of the V parameter values (For Forms and Bar Code Card: 33, 13, 13, 10, and 34
respectively in the table above) is considered in the RSS-14 AIM specification as a multiple of
"X", which is a "module width", assumed to be 1 by bar code engine.
• Only the value for Bar Width 1 is needed for the design of the 2D addon. All other bar widths
are dependent on the value of Bar Width 1.
• The S parameter does not work correctly on the HP BarDIMM and also with the Forms and
Bar Code Card. Setting S1 to any value does not affect the bar code like it does with B1. The
S parameter should vary the whitespace widths on the Forms and Bar Code Card like it does
on other one-dimensional bar codes.
Range
Min:
Min. value is 1, but
symbol will be too small
to be readable.
Max:
There is no max value
but larger values will
produce a symbol that
will not fit on the page.
0=Default
1=No HRT
2=Embedded
3=Half-Embedded
4=Under
One-dimensional bar codes
24
Default
(if not specified)
8,16,24,32 (dec)
or
8,10,18,20 (hex)
0 (dec)
or
00 (dec)
Description
Optional.
Selects the width of the
spaces.
Optional.
Defines the HRT
Location.
Note: HRT is not
available on RSS-14
Stacked.