HP XM600 - Kayak - 128 MB RAM Troubleshooting Manual page 14

Your PC Workstation Does Not Start Correctly
Case 3 — Boot Process Fails and Monitor is Blank
Beep Code &
Cause...
MaxiLife LCD
3 beeps No memory, bad memory modules,
incompatible memory module
ERROR !
ERROR !
CPU Socket
Memory Error
4 beeps Graphics card problem
ERROR ! ERROR !
CPU Socket
No Video
5 beeps PnP/PCI initialization problem
6 beeps Corrupted BIOS.
7 beeps Defective system board
If You Miss the Beep Code
If you miss the beep code, turn off the PC by pressing the on/off power
button for five seconds or more, then listen for the signal again.
14
Check that...
Memory module is correctly seated in socket 1
•
(nearest processor).
If unused, memory socket 2 contains an
•
RDRAM continuity module.
Video card installed.
•
Video card seated correctly in the AGP
•
connector.
PCI cards are correctly inserted in their slots.
•
You can try removing a PCI card to see if it is
•
causing the problem.
You need to activate crisis recovery procedure
(refer to page 32).