System Board Jumpers - HP Vectra XE310 Service Handbook Chapter

hp vectra xe310 Series 1 pc

system board jumpers

Jumper
CLEAR
J6
NORMAL
DISABLE
J8
1
ENABLE
BIOS history
For the latest BIOS, the flasher utility program, and the BIOS history refer to the
HP's Web site.
beep codes for hp vectra xe310 series 1
Beep Pattern
— - - - - - - -
— - - - — —
— - - - — - - -
— - - - - - - —
— - - - - - - - —
— - - - - - - - - - -
— - - - - - - - - - -
- - — - - - - -
- - - - - - - —
— - -
-
1. Non-HP memory modules are not supported. Only HP memory modules should be used.
2. If the BIOS detects error 2C or 2E (base 512K RAM error), it displays an additional word-
bitmap (xxxx) indicating the address line or bits that failed. For example, "2C 0002" means
address line 1 (bit one set) has failed. "2E 1020" means data bits 12 and 5 (bits 12 and 5 set)
have failed in the lower 16 bits.
1-8 hp vectra xe310 Series 1 pc
Clears CMOS and passwords (to reload the Setup
program defaults)
Normal operation
Clears User and Administrator passwords
Normal operation
http://www.hp.com/go/vectrasupport/
Beep Code Numeric
Code
1-2-2-3 16h
1-3-1-1 20h
1-3-1-3 22h
1-3-3-1
1-3-4-1 2Ch
1-3-4-3 2Eh
1-3-4-3 30h
2-1-2-3 46h
2-2-3-1 58h
1-2 98h
1 B4h
Function
Description
BIOS ROM check-sum failure
DRAM refresh test failure
8042 Keyboard controller test failure
RAM module missing or not installed
1
correctly
RAM failure on address line xxxx
RAM failure on data bits xxxx
low byte of memory bus
RAM failure on data bits xxxx
high byte of memory bus
ROM copyright notice check failure
Unexpected interrupts test failure
Video configuration failure or option
ROMs check-sum failure
This does not indicate an error.
There is one short beep before
system startup.
microtower vectras
Default
NORMAL
ENABLE
2
2
of
2
of