Fan/Heat Sink Assembly - HP Presario CQ43-300 Maintenance And Service Manual

Fan/heat sink assembly

NOTE: The fan/heat sink assembly spare part kit includes replacement thermal material.
Replacement thermal material is also available in the Thermal Material Kit, spare part numbers
650277-001 (for use only with computer models equipped with an AMD processor) and 646135-001
(for use only with computer models equipped with an Intel processor).
Description
For use only with computer models equipped with an AMD processor
Fan/heat sink assembly for use only with computer models equipped with an Intel Core i5 or i3
processor and a graphics subsystem with discrete video memory
Fan/heat sink assembly for use only with computer models equipped with an Intel Core i5 or i3
processor and a graphics subsystem with UMA video memory
For use only with computer models equipped with an Intel Pentium processor and a graphics
subsystem with discrete video memory
For use only with computer models equipped with an Intel Pentium processor and a graphics
subsystem with UMA video memory
For use only with computer models equipped with an Intel Celeron processor and a graphics
subsystem with UMA video memory
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of
the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature
sensor and is designed to turn on automatically when high temperature conditions exist. These
conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan/heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
WLAN module (see
●
Keyboard (see
●
Top cover (see
●
USB board (see
●
Power connector cable (see
80 Chapter 4 Removal and replacement procedures
Battery on page 41), and then remove the following components:
Optical drive (select models only) on page
WLAN module on page
Keyboard on page 51)
Top cover on page 54)
USB board on page 63)
Power connector cable on page
49)
42)
64)
Spare part number
647316-001
646182-001
646183-001
646180-001
646181-001
646184-001