Table of Contents
Advertisement
When installing: When you attach the palm rest, do as follows:
1. Attach the fingerprint reader connector firmly to the system board.
2. Attach the palm rest so that the two projections of the palm rest ( a ) firmly fit
into the guide holes of the keyboard bezel as shown in this figure.
3. Push the front side of the palm rest until it clicks into place.
4. Close the LCD cover and turn the computer over. Then fasten the four screws
to secure the palm rest.
Removing and replacing a FRU
a
ThinkPad T61 and T61p (15.4-inch widescreen)
a
63
Advertisement
Table of Contents
