Table of Contents
Advertisement
5
Getting Started
This section provides instructions on how to begin using the MC. After completing the
following steps, you can establish a PCoIP session using a pair of PCoIP host and zero client
devices.
5.1
Start the Management Console
Follow the instructions described in sections 2.3 or 2.4 to install the MC, and then read
section 2.5 to start using it. Doing these steps activate the MC VM on the MC host machine.
Follow the instructions described in section 4.1 to open a web-browser and log in to the MC
web interface.
5.2
Discover Devices
Open the MC Device Management webpage. Verify the MC has discovered the devices you
want to link (peer). If the devices are not discovered, use the Manual Device Discovery
feature to discover the devices. The Manual Device Discovery feature is described in section
1.3.3.3.
5.3
Adding Devices to a Group
Once the PCoIP devices are discovered, you must add them to a group through the Device
Management webpage, see Figure 5-1. The following process is an example of the steps you
would take to add two zero clients to the Default group.
To add two zero clients to the Default group:
1. Open the MC Device Management webpage.
2. While pressing the "Shift" key, click the devices you want to add to a group. The selected
devices are highlighted.
3. From the Destination Group dropdown menu on the right-hand side of the screen, select
the group you want to add the devices to. In this example, the Default group was
selected.
4. Enter the device password in the Password field on the right-hand side of the screen. In
this example, the devices are assigned the same password. It's a good idea to assign the
same password to all devices in your deployment.
5. Click Add. The MC adds the selected devices to the R&D group.
TER0812002 Issue 9
PCoIP Management Console User Manual
85
Advertisement
Table of Contents
