5.
From the rear of the computer, remove the four screws that secure the power supply to the
computer.
Figure 8-35
6.
On the inside of the computer, press the tab at the front of the power supply (1), pull the power
supply forward, slide it back and toward the side of the computer so it can sit lower on the
bottom of the computer, and then rotate it and lift it out of the computer (2).
Figure 8-36
To install the power supply, reverse the removal procedure.
CAUTION:
they are not cut by the drive cage and are not pinched by the rotating power supply.
114 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
Removing the power supply screws
Removing the power supply
When installing the power supply cables, make sure they are properly positioned so